Wet Listed Industrial Emergency Light
Base Code: ELCEL-WET
Compatible Battery: B6V10A - Battery 6V, 10Ah (2 Per Pack)
Compatible Remote Head(s): RH-WP
This item has been tested and meets safety standards imposed by the Underwriters Laboratories (UL).
This unit produces Indandescent light.
This unit contains a battery for backup power. The battery must be connected during installation.
- UL 924, NEC, NFPA 101 Life Safety Code & Wet Location Listed
- Fully gasketed fiberglass corrosion-resistant enclosure
- Includes two 7.2 watts lamps
- Solid state charging circuit
- Short circuit and overload protection on DC output circuit
- Low voltage disconnect (LVD)
- Maintenance-free sealed battery
- Sealed momentary push-to-test switch & AC indicator light
Previous Product Codes: EL-WET
- Wet Listed Emergency Light
- Installation Instructions & Hardware
- SLA Battery - Must connect the battery after installation (Located inside box)
The ELCEL-WET Industrial Emergency Light is contructed from corrosion resistant fiberglass. Resistant to corrosive atmosphere, harsh environments and non-hazardous dust environments. UL listed for wet location and designed to withstand hose-downs, water spray and splashing water. Grey housing is standard.
ELCEL-WET emergency unit uses two 7.2W top mounted heads styled after Par36 lamps. Heads are constructed from high impact thermoplastic. Fully-adjustable.
Upon failure of the normal utility power, an internal solidstate transfer switch automatically provides uninterrupted emergency operation for at least 90 minutes. The fully automatic solid-state, two-rate charger initiates battery charging to recharge a discharged battery in 24 hours.
Battery - Battery Backup
The ELCEL-WET Emergency Light is designed with a maintenance-free 6 volt 10 mAh sealed lead acid battery that provides a minimum emergency duration of 90 minutes. Recharge time of the battery is 24 hours. Operational temperature range is 41°F (5°C) to 104°F (40°C). Internal heater option available which allows unit to reach 15°F (-9°C) without running the risk of the battery freezing.
Remote Head Capable Option
The remote head capability option allows the ELCEL-WET unit to supply power to up to two additional 7.2W 6V remote heads. The remote heads would then operate on the same emergency mode as the standard units (see Emergency Operation Section).
Dual voltage input 120/277 VAC operation. LED display indicates AC/ON. An external push button test switch allows maintenance personnel to quickly determine the operational status of the unit. Unit offers surge protected, solid state circuitry.
The ELCEL-WET is suitable for surface wall mounting. Hinged front access panel allows for trouble free installation and maintenance.View Installation Instructions